Journal of Advanced Materials Science and Engineering
Open Access
ISSN: 2771-666X
Research Article
View / Download PDF
Comparison of The Yield Strength of High-Entropy Solid Solutions Based on BCC and FCC Lattices Obtained in the Experiment and Calculation
Authors: Horban VF.
Abstract
Based on the literature data, high-entropy alloys based on BCC or FCC phases were selected for which the ultimate strength from 214 to 2863 MPA was determined. Knowing the chemical composition of the selected high-entropy alloys, the average elastic modulus, distortion level, and mixing enthalpy were calculated. The use of formulas that use only their atomic radius and elastic modulus, mixing enthalpy to determine the theoretical level of hardness made it possible to establish the yield strength based on the ratio s0,2=0,3H.
Citation:
Horban VF. Comparison of The Yield Strength of High-Entropy Solid Solutions Based on BCC and FCC Lattices Obtained in the Experiment and Calculation. J Adv Mater Sci Eng. 2024; 4(2).
DOI:
10.33425/2771-666X.1025
Editor-in-Chief
Abdelilah Lahmar
Materials Science Engineering | Picardie Jules Verne University
View full editorial board →
Journal Metrics
Impact Factor
2.1*
Acceptance Rate
75%
Time to first decision
6-10 Days
Submission to acceptance
12-15 Days